LabMaster Coating Methods

Coating Modules are interchangeable so the LabMaster Pilot Line can be configured for a variety of coating methods that satisfy a broad range of applications. An assortment of optional coating modules can be added at any time. Coating modules can be configured for roll coating or slot-die coating using water, solvent, or hot-melt coating methods.*

The base LabMaster configuration includes two unwinds, roll coating module, 3-meter dryer, dry bond laminator module with chill rolls, and rewind with integrated drives and controls. An additional 3-meter dryer zone can be ordered with the machine or added at any time. A wet bond laminator is also optional.

Standard Coating Module Configurations

Coating Method Direct Gravure Forward

Direct Gravure
Forward

Coating Method Offset Gravure Reverse Coating Modules

Direct Gravure
Reverse

Coating Method Offset Gravure Forward Coating Modules

Offset Gravure
Forward

Coating Method Offset Gravure Reverse Coating Modules

Offset Gravure
Reverse

Coating Method One Roll Smooth Kiss Forward Reverse Coating Modules

One Roll Smooth
Kiss-Forward/Reverse

Coating Method Two Roll Smooth Kiss Forward Reverse Coater Modules

Two Roll Smooth
Kiss-Forward/Reverse

Coating Method Two Roll Smooth Nip Forward Coater Modules

Two Roll Smooth
Nip Forward

Coating Method Three Roll Smooth Nip Forward Coater Modules

Three Roll Smooth
Nip Forward

Coating Method Polishing Bar Coater Modules

Polishing Bar
Typical

Coating Method Mayer Rod Coater Modules

Mayer Rod

Optional Coating Modules

Coating Method Reverse Roll Coater Modules

Reverse Roll
Optional

Coating Method Slot Die Coater Modules

Slot Die
Optional

Coating Method Knife Over Roll Coater Modules

Knife Over Roll
Optional

* Optional equipment may be required.